BOGIE KIT 4MM – GLOUCESTER MKIII (RIGID) – CC55B-MKIII

£9.99

sold out

The kit consists of:

1 x Etched sheet containing 2 etched frames.

4 x Pewter side frame castings.

Required: 4 x 12mm Ø wheel-sets on 26mm pinpoint axles, 8 x 2mm shouldered pin point bearings and pivot arrangements to complete. The mounting pivot hole is a nominal 2mm Ø.

Will make up 1 pair of bogies.

Please download Instructions from the link below

CC55B Gloucester MkII, III, and IV Rigid Bogies v2

There is provision made on this bogie for the Stenson Models Coupling Mount for those modellers that require to fit any compatible NEM coupling.

Add To Cart

The kit consists of:

1 x Etched sheet containing 2 etched frames.

4 x Pewter side frame castings.

Required: 4 x 12mm Ø wheel-sets on 26mm pinpoint axles, 8 x 2mm shouldered pin point bearings and pivot arrangements to complete. The mounting pivot hole is a nominal 2mm Ø.

Will make up 1 pair of bogies.

Please download Instructions from the link below

CC55B Gloucester MkII, III, and IV Rigid Bogies v2

There is provision made on this bogie for the Stenson Models Coupling Mount for those modellers that require to fit any compatible NEM coupling.

The kit consists of:

1 x Etched sheet containing 2 etched frames.

4 x Pewter side frame castings.

Required: 4 x 12mm Ø wheel-sets on 26mm pinpoint axles, 8 x 2mm shouldered pin point bearings and pivot arrangements to complete. The mounting pivot hole is a nominal 2mm Ø.

Will make up 1 pair of bogies.

Please download Instructions from the link below

CC55B Gloucester MkII, III, and IV Rigid Bogies v2

There is provision made on this bogie for the Stenson Models Coupling Mount for those modellers that require to fit any compatible NEM coupling.